McDATA ULTRANETTM EDGE STORAGE ROUTER 3000 Guide de l'utilisateur télécharger pdf (Page 122)

100

101

6-16

McDATA UltraNet Edge 3000 User Guide

Configuring a 2x2 Ethernet Wide Area Network

At this time you can configure the gateway address (the router IP

WAN address attached to the UltraNet Edge 3000) to create a

static route to the destination IP address (Node20 in this example)

by continuing through the remainder of the steps in this

procedure.

NOTE: If you do not know what the router IP address attached to the

UltraNet Edge 3000 is at this point, you can add the static route at a later

time. To add static routes at a later time, see Appendix E, Static Routes.

9. Check Set, enter the IP Address of the router directly attached to

the IP WAN interface of Node10 to set the static route.

NOTE: If you are using the Configuration IP Address Worksheet from Appendix

J, enter the following information:

For Node10, enter the gateway address labeled for the circuit on a 1x1 or

2x1 configuration or the 1st circuit of a 2x2 or 1x2.

For the 2nd circuit of a 2x2 or 1x2 configuration, enter the gateway address

labeled .

10. Click Next>.

The IP Circuit Wizard Node20 Choose Interface dialog box

appears (Node20 is the destination node).

This drop-down menu displays the available IP interface

providers in the UltraNet Edge 3000 box for Node20.

1 2 ... 117 118 119 120 121 122 123 124 125 126 127 ... 427 428

Commentaires sur ces manuels

Pas de commentaire

McDATA ULTRANETTM EDGE STORAGE ROUTER 3000 Guide de l'utilisateur Page 122

Commentaires sur ces manuels

Produits connexes et manuels pour Mise en réseau McDATA ULTRANETTM EDGE STORAGE ROUTER 3000