McDATA OPENconnectors Command Line Interace Manuel d'utilisateur télécharger pdf (Page 163)

100

101

CLI Commands

2-119

config

Purpose This command enables syslog support for the given log.

Parameters This command has two parameters:

Command Example

Root> config syslog setLogConfig event enable

config.syslog.setState

Syntax setState enabledState

Purpose This command sets the enabled or disabled state for the syslog

feature.

Parameters This command has one parameter:

Command Example

Root> config syslog setState enable

config.syslog.show

Syntax show

Purpose This command displays the syslog configuration.

NOTE: The command show.syslog on page 2-251 has functionality that is the

same as this command.

Parameters This command has no parameters.

logName The log type. Possible values are Event, Trunking,

Link, Security, Audit, Fabric, and Frame.

state This parameter can be set to enable or disable.

Boolean 1 and 0 values may also be substituted. If

the state is enabled, messages for that log will be

sent to the configured syslog servers.

enabledState This parameter can be set to enable or disable.

Boolean 1 and 0 values may also be substituted.

1 2 ... 158 159 160 161 162 163 164 165 166 167 168 ... 405 406

Commentaires sur ces manuels

Pas de commentaire

McDATA OPENconnectors Command Line Interace Manuel d'utilisateur Page 163

Commentaires sur ces manuels

Produits connexes et manuels pour Mise en réseau McDATA OPENconnectors Command Line Interace