McDATA OPENconnectors Command Line Interace Manuel d'utilisateur télécharger pdf (Page 206)

100

101

2-162

E/OS Command Line Interface User Manual

perf

Parameters This command has one parameter:

TIP: Although the system supports a name length of 64 characters, you may want to

use a much shorter name. Some commands that display the threshold name show a

maximum of 51 characters. If you specify lengthy names, you can display the complete

name by entering the comma-delimited mode using the commaDelim command. For

more information, see Using the commaDelim Command on page 1-19.

Command Example Root> perf thresholdAlerts counter addAlert checklinks

perf.thresholdAlerts.counter.addPort

Syntax addPort name portNumber

Purpose This command adds a port to the specified counter threshold alert.

NOTE: An alert cannot be modified unless it is in the disabled state. Verify

that the alert is disabled before executing this command.

Parameters This command has the following parameters:

name Specifies the name of the new counter threshold

alert. This name can consist of any ASCII characters

up to a maximum length of 64 characters. To use

spaces or special characters in this name, put

quotation marks around the name. This parameter

is case-sensitive.

name The name of a counter threshold alert as defined by

the command perf.thresholdAlerts.counter.addAlert on

page 2-161.

1 2 ... 201 202 203 204 205 206 207 208 209 210 211 ... 405 406

Commentaires sur ces manuels

Pas de commentaire

McDATA OPENconnectors Command Line Interace Manuel d'utilisateur Page 206

Commentaires sur ces manuels

Produits connexes et manuels pour Mise en réseau McDATA OPENconnectors Command Line Interace