McDATA OPENconnectors Command Line Interace Manuel d'utilisateur télécharger pdf (Page 117)

CLI Commands

2-73

config

fabric to provide additional connection information to host bus

adapters (HBA) and storage devices. As an example, this information

might be that a logical path has been broken because of a physical

event, such as a fiber optic cable being disconnected from a port.

Parameters This command has one parameter.

Command Example

Root> config switch domainRSCN 1

config.switch.edTOV

Syntax edTOV timeoutValue

Purpose This command sets the E_D_TOV for the switch.

NOTE: The switch must be set offline before this command is entered.

Special care should be used when scripting this command due to its

relationship with R_A_TOV.

Parameters This command has one parameter.

Command Example

Root> config switch edTOV 4

config.switch.insistDomainId

Syntax insistDomainId insistentDomainIdState

Purpose This command sets the insistent domain ID state for the switch.

domainRSCNState Specifies whether the domain RSCN state is

enabled. Valid values are enable and disable.

Boolean 1 and 0 may be substituted as values.

timeoutValue Specifies the new E_D_TOV value. The units for

this value are tenths of a second. This parameter

must be an integer in the range 2–600

(0.2 second to 60 seconds), and it must be

smaller than the R_A_TOV.

1 2 ... 112 113 114 115 116 117 118 119 120 121 122 ... 327 328

Pas de commentaire

McDATA OPENconnectors Command Line Interace Manuel d'utilisateur Page 117