McDATA OPENconnectors Command Line Interace Manuel d'utilisateur télécharger pdf (Page 275)

Error Messages

A-35

Message Error 224: Invalid Argument

Description One or more parameters are invalid for this command.

Action Consult this manual (Chapter 2, CLI Commands) for appropriate

parameter names. Parameters must be typed exactly to specification

to be recognized correctly by the CLI.

Message Error 226: Argument Is Too Long

Description One or more parameters are invalid for this command.

Action For the appropriate parameters, see the section of the manual that

corresponds to the attempted command. Parameters must be typed

exactly to specification to be recognized correctly by the CLI.

Message Error 227: Invalid SNMP Community Name

Description The value entered for the SNMP community name is invalid.

Action The community name must not exceed 32 characters in length.

Duplicate community names are allowed, but corresponding write

authorizations must match. Enter an appropriate SNMP community

name and re-submit.

Message Error 228: Invalid Write Authorization Argument

Description The writeAuthorization parameter does not contain a valid value.

Action Parameters must be typed exactly to specification to be recognized

correctly by the CLI. For more information, see

config.snmp.addCommunity on page 2-68.

Message Error 229: Invalid UDP Port Number

Description The udpPortNum parameter does not contain a valid value.

Action Parameters must be typed exactly to specification to be recognized

correctly by the CLI. For more information, see

config.switch.insistDomainId on page 2-73.

1 2 ... 270 271 272 273 274 275 276 277 278 279 280 ... 327 328

Pas de commentaire

McDATA OPENconnectors Command Line Interace Manuel d'utilisateur Page 275