McDATA OPENconnectors Command Line Interace Manuel d'utilisateur télécharger pdf (Page 155)

CLI Commands

2-111

perf

the preferred path. All configured paths can be removed by

specifying the all parameter for both the destination domain ID and

source port.

Parameters This command has the following parameters.

Command Example

Root> perf preferredPath clearPath 10 5

perf.preferredPath.setPath

Syntax setPath destDomainID sourcePort exitPort

Purpose This command sets a preferred exit port given the destination domain

ID and source port. An exit port can be set for each combination of

destination domain ID and source port.

NOTE: You cannot set a path where the Destination Domain ID is the same as

the Switch's Domain ID.

destDomainId Specifies the destination domain ID. Valid

domain IDs are in the range 1–31 or all, which

deletes all preferred paths to and from the

source port specified in the sourcePort

parameter.

sourcePort Specifies the number of the source port. Valid

port numbers values are:

0–11 for the Sphereon 4300

0–15 for the Sphereon 3016 and 3216

0–23 for the Sphereon 4500

0–31 for the Sphereon 3032 and 3232

0–31 for the ED-5000

0–63 for the Intrepid 6064

0–127 and 132–143 for the Intrepid 6140

Or you can specify all to delete all paths to the

destination domain ID.

1 2 ... 150 151 152 153 154 155 156 157 158 159 160 ... 327 328

Pas de commentaire

McDATA OPENconnectors Command Line Interace Manuel d'utilisateur Page 155